Full Elite RR performance exhaust system, suitable for all XK8/R from 1996-
Quad tips available -
Half Elite RR performance exhaust system, suitable for all XK8/R from 1996-
Quad tips available -
Elite RR quad tailpipes, designed to fit directly on to our full and half systems above, these are a perfect fit on the later cars deeper rear valence with wider opening, 304 grade stainless, mirror polished, rolled in design with internal perforation for a sportier look.
£1350.00
Inc. Free fitting
£925.00
Inc. Free fitting
£355.00
Inc. Free fitting
Elite RR Half under axle performance exhaust system, suitable for all XK8/R from
1996-
Infact it offers the best possible flow rate and performance improvement.
Made from 304 grade stainless steel and mirror polished throughout, superb sound with straight under the axle design, comes with all clamps and fittings, supplied with 3.5” round inwardly rolled and finished tailpipes. Gives approximately 18bhp gain. Click the video link for a short clip.
£630.00
Elite RR sports catalysts, using 200cell monolith for performance and longevity, 304 grade stainless, polished finish, twin lambda sensor bosses complete with blanking plug for single sensor fitments, improved gas flow gives increased performance, when combined with our sports exhausts they offer excellent increases in midrange torque.
They will fit all 1996-
Supply only
£1225.00
Supplied & fitted
£1625.00
Carbon dynamic induction system, suitable for all XK8/R 1996-
Performance ‘drop in’ air filter, ‘Green’ panel filter offers excellent flow and
filtration and retains the factory air box for a stealthy look and simple fitment,
only requires periodic washing and re-
Modified lower pulley assembly, a billeted supercharger pulley is fitted to a modified
crankshaft damper, supplied with longer supercharger drive belt, gives a 10% increase
in supercharger speed -
This is an exchange unit, we require your old pulley back for modification.
Suitable for all XKR’s 1998-
Alloy supercharger pre rad, offers increased capacity by approx 250% and reduced intake temperatures, this in turns gives a better base for increasing performance with stable results due to lower heat soak/buildup.
Suitable for all XKR’s 1998-
Re-
We can supply a dyno graph for before and after comparisons, especially useful if having a lot of upgrades performed at once or to check your cars current output.
All dyno runs are carried out with respect to the vehicle, no abnormal loads are applied, it is effectively the same as exploiting your vehicles performance to the full on the road.
We advise vehicles be in good running order and properly serviced/maintained prior to any tuning work
Brake upgrades, Brembo brake upgrades using second hand callipers & braided goodridge
hoses with new aftermarket drilled discs and mintex pads, suitable for all XK8/R
1996-
Minimum wheel size of 19” required.
Prices on these vary due to condition of used parts, please use the price here as a guide, price confirmed at time of booking/order.
Supply only
£330.00
Supplied & fitted
£445.00
£54.95
Inc. Free fitting
Supply only
£355.00
Supplied & fitted
£499.99
Supply only
£650.00
Supplied & fitted
£775.00
Supplied & fitted
£799.00
£155.00
Per Graph/Run
Lowered suspension, available for all XK8/R 1996 onwards, progressive rate springs give a drop of 30mm, offers enhanced looks, sharper handling & better road holding, fitting includes geometry set up.
Supplied & fitted
£875.00
Supplied & fitted
£1400.00
Price will be confirmed with booking/order
Fitment of the latest new XK alloys to your pre 06 model is now as easy as can be, using specially made solid alloy wheel adaptors that both space the new wheels correctly to obtain the right offset & convert the bolt pattern and wheel centre to the right sizes, includes all the required parts to fit post 2006 XK alloys, four adaptor plates & 20 wheel nuts for the adaptors.
Late model alloy alloys are cheaper and better wearing than the older bbs styles which are increasing hard to find in good condition, we can source/supply late alloys as well, please ask if you are uncertain or require further information.
Supply only
£332.00
One piece flat mesh grille, suitable for all XK8/R 1996-
One piece convex mesh grille, suitable for all XK8/R 1996-
Rear lamp conversion, Suitable for all XK8/R 1996-
2003 model year chrome boot plinth, can be wired to be operational boot release & colour coded if required, suitable for all pre 2003 XK8/R
Pre 2005 xkr boot spoiler, OE item, colour coded to match existing paintwork, suitable for any pre 2006 XK without a spoiler
Post 2005 XKR rear spoiler, OE item, colour coded to match existing paintwork, these are much deeper approx 3” and set the car off beautifully, suitable for any pre 2006 XK without a spoiler.
Full 2005 front end conversion, using all genuine Jaguar parts, brings an early XK8/R upto 2005 spec, includes: nosecone,undertay,mesh grille, number plate plinth,arch liners,fog lights & all fixings, colour coded & fitted.
2005 spec side skirts, includes clips & retainers, OE genuine side skirts, colour coded and fitted, fits all pre 2005 XK’s
2005 rear bumper upgrade, includes: bumper cover, wheel arch liner extensions, side mounts, colour coded and fitted
Powder coated calliper re-
‘Jaguar’ artwork can be applied by means of high temperature vinyl if required at additional cost.
New brake pads and discs can be fitted at cost of parts only if carried out at the same time.
Alloy wheel upgrades, we can source most 20” alloys in as new or used condition, prices vary hugely dependent on style and condition.
Please contact us with requirements
Wheels for the new XK (2006 onwards) are also available.
Alloy wheel refurbishment, we can refurbish all alloy wheels including split rim,
wheels are stripped, acid dipped, checked for damage and then re-
Prices vary depending on size and single or two piece design.
3 ring dash set, cnc turned from aluminium tube, pre formed to fit the dash panels curvature, these can be polished to a near chrome like shine if desired or left as a matt aluminium finish
6 ring dash set, cnc turned from aluminium tube, pre formed to fit the dash panels curvature, these can be polished to a near chrome like shine if desired or left as a matt aluminium finish
Chrome plated ‘J’ gate surround, replaces the black plastic surround, available with one or two button mounting points, contoured to match the originals shape.
‘R’ type gear knobs also available.
3 piece aluminium foot pedal set, brake and clutch pedals are curved to fit existing pedal contours, complete with fixings.
Interior wood panel upgrades, shown is our ‘midnight flake’ finish, deep rich black with plenty of sparkle in bright direct sunlight, not at all overt instead this gives a very stylish contemporary modern feel to the dashboard, we can also incorporate logos under the clear coat.
Other finishes available, virtually unlimited choice.
Supercharger boost gauge, anlogue gauge reading to 20psi of boost, we can custom make a gauge pod for mounting and trim this in leather to match existing interior trim.
Supply only
£160.00
Supply only
£185.00
Supplied & fitted
£710.00
Priced from
£160.00
£510.00
Supplied & fitted
£420.00
Supplied & fitted
£1950.40
Supplied & fitted
£755.00
Supplied & fitted
£1150.00
Supplied & fitted
£495.00
Supply only
£355.85
We require callipers sent to us removed from the vehicle
Supplied from
£2000.00
Inc. Free fitting
Supplied & fitted
£425.00
Inc. Free fitting
Example for four
19” alloys
Supply only
£75.00
Supply only
£115.00
Supply only
£175.00
Supply only
£225.00
Supplied & fitted
£655.00
Incl. Steering wheel sections
£910.00
Supply only
£185.00
Post 2005 XKR spoiler, OE item, modified in house to incorporate a third brake light, using a high intensity LED light unit flush mounted within the spoiler unit, requires colour coding and fitting in house at our bodyshop.
Supplied & fitted
£695.00
Front number plate lowering plinth for the 2005 front nose cone, constructed from fibreglass to fit snugly into the lower section of the nose cone, colour coded to match existing paintwork.
Supplied & fitted
£270.00
Supplied & fitted
£355.00
HID Zenon headlamp conversion, using state of the art digital high intensity discharge
units retro-
Suitable for all XK8/R’s
Prices may fluctuate due to supplier price increases, Jaguar components are most affected and can alter on a monthly basis, for this reason we will always confirm prices at point of order.
All goods returned shall be refunded at the discretion of EAPJ.
All returns will be subject to a handling fee of 10%